AMD drivers on Boreal+ and Taiga+
Some Hippotizer Nevis+ units have been shipped with Windows updates enabled. This may impact start-up behaviour and potentially cause some issues with hardware configuration if the drivers are changed...
The new 3.1 firmware update for the Rosendhal Mif4 MIDI timecode interface is required for the device to be compatible with the newer range of Hippotizer servers including: Tierra+ Tierra+ MK2 Nevis+ ...
If you are experiencing engine crashes, or freezes, when loading newer Notch blocks we recommend updating the firmware for the CMDongle. This can be completed by opening th CMContainer in the task bar...
The new Nevis+ system has brought with it a brand new EDID management tool located in the HippoLauncher application. This tool allows the user to manage EDID emulation for configuring display timings....
VisionSC Range VisionSC-UHD2 (2 x HDMI 2.0) (only available in 4u/2u chassis - NOT Amba+ MK2) VisionSC-SDI4 (Quad SDI) (only available in 4u/2u chassis - NOT Amba+ MK2) VisionAV Range VisionAV-SDI (1 ...
We are always striving to get the most out of our units and we will regularly test new drivers for the components within the machines. Since we released the Taiga+ and the Boreal+ the drivers for the...
If you are using the TIERRA and NOTCH, please install the VS2013 and VS2015 redistributables found here....
YOU MAY NEED TO INSTALL NEW DISPLAY DRIVERS BOREAL+ and TAIGA+ units may have AMD driver version 18Q1 installed from factory. 18Q1 is not stable, and may lead to crashes or un-commanded system reboots...
V4 KARST with RX570 cards running at 30Hz on output will stutter without HDCP turned off. These cards require a specific driver which should not be changed. Initial tests confirm the FPS monitor was...
The 4.4.x version of Hippotizer has a lot of changes in it. You should check your Hippotizer has been cleaned up by uninstalling previous versions and folders before installing any version of V4.4.x. ...